Pipe bending machine
Contact: Eric Hwang
Contact: Andy Wang
1, CNC tube bending machine is connected to the power supply, open the switch on the control panel, and then start the pump, so you can hear the voice of oil pump rotation. (at this time the machine does not move)
2, CNC pipe bending machine travel adjustment, the use must pay attention to the adjustment of the stroke, must be tested before the bending. It must be guaranteed to have a thick gap when the upper die is down to the bottom. Otherwise, it will cause damage to the mold machine. The adjustment of the stroke is also an electric quick adjustment.
3, bending slot selection, generally choose the plate thickness of 8 times the width of the slot. If the sheet of 4mm is bent, it is necessary to choose about 32 of the slot.
4, the rear gear adjustment usually has electric fast adjustment and manual micro adjustment, and the method is with the cutting plate machine.
5, step down the foot switch to start bending, CNC automatic pipe bending machine die and the shearing machine different, can be loosened at any time, loose feet then stop, and continue down.