Shredder Machine Email: brighter@chinaplasmachine.comPipe Bending Machine Email:eric.hwang@wonsten.com Wonsten Group

Wonsten Group

Pipe Bending Machine Manufacturers Explain The Daily Maintenance And Maintenance Of The Pipe Bending Machine

When cleaning the oil box of the pipe bending machine, we should clean the oil filter of each pump. CNC pipe bending machine manufacturer

2. Within 1 to 2 months after the equipment is used, the oil tank is cleaned and a hydraulic tank is filtered.

3, if we find that the advance and retreat failure is unsuccessful, first check whether the solenoid valve acts, if the solenoid valve acts normally, then check whether the sequential valve 6X3, the relief valve YF L20H4 or the one-way unloading valve 4HD3 have the impurity sticking phenomenon. (this phenomenon is usually easy to happen when the equipment is started). If there is a dead card phenomenon, disassemble the gasoline or diesel oil after cleaning it, reload it.

4, the hydraulic pump station parts are equipped with oil resistant rubber seal ring, such as seal ring damage, oil leakage, should be changed in time.

5. Check the fasteners of each part to make the parts fasten.


Copyright © wonsten group All Rights Reserved.
QR Code