Shredder Machine Email: brighter@chinaplasmachine.comPipe Bending Machine Email:eric.hwang@wonsten.com Wonsten Group

Wonsten Group

What Are The Problems That Should Be Noted Before The Operation Of The Shredder?

Equipment for biaxial shredding machines must be fixed and shall be fixed on cement foundation. If you often work in different places, and must be installed in the motor and made with angle iron frame. If the equipment is powered by a diesel engine, the power of both should be matched, i.e., the power of the diesel engine is slightly larger than the power of the crusher, and the pulley grooves of the two belts are identical. The outer surface of the pulley should be on the same plane. Before you turn on the machine, you must check all parts of the machine, whether the connecting bolts are fastened, whether the tightness of the driving belt is right or not, whether the power line is good or not. Is the motor shaft parallel with the crankshaft of the equipment?.

 

Check whether the hammer is good or not, the screen is suitable for the hole, whether or not damaged. With the hand drive belt, check spindle rotation is flexible, there is no card, collision and friction phenomenon. After the equipment is switched on, let the equipment idle for 2 to 3 minutes to check whether the rotor is correct and the sound is normal. It works only when the rotation speed is steady at rated speed. Work should always pay attention to the operation of equipment, feeding should be uniform, in order to prevent blocking the stuffy car, do not overload work for a long time. If there is vibration, noise, bearing and the body temperature is too high, outward spraying and other phenomena, should immediately stop inspection, troubleshooting can continue to work.

 

Be sure to pay attention to shredding machine equipment, crushing materials should be carefully checked, must not be mixed with stones, metals and other foreign bodies, so as not to damage the machine. When the machine is in operation, the operator shall not leave the unit, and shall not disassemble in the operation room observed the work of grinding, maintenance tools shall not be placed on the machine or packing


Copyright © wonsten group All Rights Reserved.
QR Code